Henny Penny 500 Service Manual page 148

FEELER
GAUGE
HERE
17. Slip the spindle thru the limit stop, hold the idle
nut against the acme nut, and thread spindle thru
% '< g:*,.
both. There should be 20 to 60 thousandths be- 'W
tween the acme nut and the idle nut. To increase
dimension turn the idle nut bounterclockwise; to
decrease turn clockwise.
nstall the locking collar, locking pin and ball. In-
stall the ball seat in the lid. Install the retainer and
spring.
eassemble the crossbar to the lid cover according
to the "Lid Cover Installation" procedure.
eadjust the lid limit stop during the test frying
cycle.
The filtering system consists of the filter valve, motor
and filter pump assembly, filter screen assembly, and
tubing.
Shortening with temperature in excess of 2WF
flows through this filter rinse hose. Heat causes
the rubber hose to age and deteriorate. The hose
and fittings should be checked daily. If aging or
discoloration is seen, the hose should not be used.
Severe burns will result if this rinse hose assembly
leaks or ruptures.
1. Close the filter valve.
urn the pump switch to the
3. Detach the hose
result e
This hose is n