Henny Penny 500 Service Manual page 23

el
The gas fryer requires 120 volt, single phase, 60
10 amp, 3 wire grounded service. The gas fryer
tory equipped wit
and plug.
DO NOT DISCONNECT THE GROUND PLUG.
This fryer MUST be adequately and safely
grounded or electrical shock could result. Refer to
local electrical codes for correct grounding
procedures or in absence of local codes, with The
National Electrical Code, ANSIlNFPA No. 70-
Latest Edition. Canadian models are supplied with
a terminal box, suitable for conduit connection.
In Canada, all electrical connections are to be
made in accordance with GSA C22.1, Canadian
Electrical Code Part 1, and/or local codes.
enny Penny pressure fryer was completely
checked and tested prior to shipment.
owever, it is
good practice to check the unit again after installation.
Any deviation from the following steps may re-
sult in damage to the fryer.
1. ove all switches and controls to the OFF position.
2. aise the lid.
emove all items including basket from the frypot.
4. Turn on the main power supply to the fryer using
the main circuit breaker.
5. ove the main power switch on the fryer control
panel to the POWE
The indicator light will illuminate showing
power is present at the fryer.