Henny Penny 500 Service Manual page 126

.
move the control panel er paragraph 5-4.
.
el the wires and remove them from the TI
screws securing the
to the
Replacement of the TIMER may not be necessary
if the lamp is burned out, or if the buzzer coil is burn-
ed open, or if the on-off switch is bad. Also timer
motor & timer microswitch can be replaced
separately.
1. isconnect light wires from terminal board.
emove and discard the bad light assembly.
nstall new light assembly allowing the retainers
to snap into place.
1. Connect light leads to terminal board of T
2. emove switch nuts and remove switch from panel.
3. isconnect switch wires from terminal board.
nstall new switch on panel and secure with switch
nut.
5. Connect switch wires to the terminal board of the
1. emove buzzer and coil from .
ect buzzer coil wires prom terminal
uzzer and coil to
.
Connect coil
Of
.
), 'b
nsta1
*i
.
'/ u'