Henny Penny 500 Service Manual page 114

ode1 500/600/56~
. GA
OL
VALVE (continue
Gasket Operator
Reghator
4. Remove the 90" connector and conduit from the old gas valve
and install on the replacement gas valve.
5. Remove the four screws securing the operator and gasket.
6. Secure the new operator and gasket with the four screws
provided.
7.
Reconnect the gas valve wires.
8. Install the control panel per paragraph 5-4.
Check Procedures
120 volt - 50/60 Hz - 235-ohms
208-240
volt - 50/60 Hz - 880-ohms
24
volt - 50/60 Hz - 7 ohms
1. Remove the hvo screws securing regulator to the operator.
2. Replace with the new gasket and regulator and secure with the
two screws supplied.