Henny Penny 500 Service Manual page 103

I
1. Drain the shortening.
SPREADERS
2.
move the thermostat bulb holder from the heat-
ing element inside the frypot.
3.
move the heating element wires from the termi-
nals by removing nuts (5) and washers (6 and 7).
Label each so it can be replaced in the same position
on the new element.
4. Loosen the bolts on the four element spreaders.
5. Slide the element spreaders to the center of the
heating element.
6. Remove the brass nuts (4) and washers (3), which
secure the ends of the elements through the frypot
wall.
emove the heating elements from the frypot as a
group by lifting the far end and sliding them up and
out toward the rear of the frypot.
Always install new rubber 0 rings (2) when install-
ing heater elements.
8. Install new heating elements with new rubber 0 rings
(2) mounted on terminal ends, and spreaders loosely
mounted in the center of the stacked elements.
9. place the heating elements, terminal end first at
approximately 45" angle, slipping the terminal
ends through the front wall of the frypot.