Henny Penny 500 Service Manual page 102

ce t
Each electric fryer uses three heating element as-
semblies.
eating elements are available for 208,220/240,
or 440/480 voltage. Check the data plate inside
the door to determine the correct voltage.
If the shortening's temperature recovery is very slow, or
at a slower rate than required, this may indicate defec-
tive heating element(s). An ohmmeter will quickly in-
dicate if the elements are shorted or open.
1. Remove electrical power supplied to the fryer.
~E~/OFF/P~~P switch to the OFF
d unplug the power cord or open the
wall circuit breaker, or electrical shock could
result.
1 panel and insert it in
fer to paragr
rform an ohm check on one heating element at a
time, with wires disconnected from element. If the
resistance is not within tolerance, replace the ele-
ment.
HEATER RESISTANCE IN
PIN POWER VOLTAGE OHMS (COLD)
18233-1 45oow 208VAC 9&l
18233-2 4500w 230VAC 11+1.5
18233-4 3750w 208VAC llIk1.5
18233-5 3750w 220VAC 1222
18233-6 3750w 48OVAC 6025
18233-7
4500w 480VAC 50+4
18233-8 4500 380VAC 32k3.5 ';!a