Henny Penny 500 Service Manual page 63

CHEMICAL
SPLASH
GOGGLES
2.
3.
4.
If hot shortening is present in the frypot, it must be
drained by slowly opening the drain valve handle one
half turn. Leave for a few minutes, then slowly open
the valve to the full open position.
Close the drain valve. Discard the shortening in the
filter pan. Then install the filter drain pan under the
fryer., leaving out the filter screen assembly.
Moving the frypot with hot shortening in the
frypot or filter pan is not recommended. Hot
shortening can splash out. Severe burns could
result.
Fill the frypot to the level indicator with hot water.
Add 4 to 6 ounces of fryer cleaner (Henny Penny part
number 12101) to the water and mix thoroughly. The
fry basket can be placed inside frypot for cleaning.
Always wear chemical splash goggles or face
shield and protective rubber gloves when clean-
ing the frypot as the cleaning solution is highly
alkalilie. Avoid splashing or other contact of the
solution with your eyes or skin. Severe burns
and possible bindness will result. Carefully read
the instructions on the cleaner. If solution comes
in contact with your eyes, rinse thoroughly with
cool water and see a physician immediately.
c o. Set the thermostat to 195OF and turn main power
switch to the POWER position.
NEVER PRESSURIZE FRYER TO CLEAN.
Leave the lid open. Water under pressure is
super heated and ,will cause severe burns if it
comes in contact with skin.