Henny Penny 500 Service Manual page 143

egin the installation by installing the four cor-
ners of the lid gasket.
The lid limit stop, with proper adjustment, will prevent un-
necessary overtightening of the spindle, and as a result, will
extend the life of the lid gasket.
1. Loosen the allen set screws on the bottom of the collar
of the limit stop assembly. Turn limit stop clockwise
as far as possible.
2. Close lid and turn spindle until lid gasket meets the
top of the fry pot rim.
rom this position, turn spindle at least -?A of a turn,
but not over one full turn.
4. fter rotating spindle to thi
int, slightly extend the
spindle past this position.
e spindle should then
be at the seven o'clock position.
seven o'clock position is only to allow slight
tional turning of the spindle to relieve any side
ure that could hold the locking pin in the locking
collar after all pressure has been released from the
fry pot.