Henny Penny 500 Service Manual page 84

el 5
This section provides procedures for the checkout and
replacement of the various parts used within the fryer.
Before replacing any parts, refer to Section 4, Trou-
bleshooting. It will aid you in determining the cause of
the malfunction.
This section is arranged in groupings of the components
that work together within the fryer. The general groups
are listed below. Refer to the Table of Contents in the
front of this manual if more details are needed.
@ Removing the Control Panel
@ Temperature Regulation
@ Electrical Components
0 Timing Control
0 Pressure Regulation
Filtering System
Fryer Conversion Procedures
1. You may use two test instruments to check the
electric components.
A continuity light.
An ohmmeter.
2. When the manual refers to the circuit being closed,
the continuity light will be illuminated or the
ohmmeter should read zero unless otherwise noted.
3. When the manual refers to the circuit being open,
the continuity light will not illuminate or the
ohmmeter will read 1 (one).
A continuity tester cannot be used to check coils
or motors.