Henny Penny 500 Service Manual page 128

-71
I I
LIGHT \
I
I
J
--
---
NC
NC
12
Ll
his is an electro-mechanical device that causes pres-
ot. The solenoid valve closes at
mg cycle and is opened automat-
ically by the timer at the end of the frying cycle. If this
valve should become dirty or the teflon seat nicked,
pressure will not build up. The solenoid valve used on
all models is the same with the exe ion of the coil. The
gas modelfryer uses a 120 volt, 6
model fryer uses a 208/240 volt 6
volt electric model uses a transformer to drop voltage to
220/240
volts.
efore starting repair procedures, move
AIN
switch to OFF position.
isconnect main
circuit breaker at the circuit breaker box and/or
unplug service cord from wall receptacle, or
electrical shock could result.
1. emove wires from terminals 73 an
across solenoid wires if without
switch.
120 volt 60 Hz
208-240 volt 60
Hz 150 ohms
208-240 volt 50 Hz 245 ohms
emove wires from terminals 70 and 73 and check
solenoid wires with SO
switch in
position.
208-240 volt 60 Hz 150 ohms
208-240 volt 50 Hz 245 ohms.