Installing The Adapter Module - ABB FCAN-01 User Manual

28 Mechanical installation

Installing the adapter module

WARNING! Obey the safety instructions. See chapter
Safety instructions
instructions, injury or death can occur.
The adapter module has a specific position in the drive. Plastic
pins, a lock and one screw hold the adapter module in place. The
screw also makes an electrical connection between the module
and drive frame for cable shield termination.
When the adapter module is installed, it makes the signal and
power connection to the drive through a 20-pin connector.
When you install or remove the adapter module from the control
unit:
1. Pull out the lock.
on page 11. If you ignore the safety
1