Starting Up Acsm1 Drives - ABB FCAN-01 User Manual

64 Start-up
Drive parameter
1102 EXT1/EXT2 SEL
1103 REF1 SELECT
1106 REF2 SELECT
1601 RUN ENABLE
1604 FAULT RESET
SEL
1)
Automatically detected
2)
Example
The start sequence for the parameter example above is given
below.
Control word:
•
Reset the fieldbus communication fault (if active).
•
47Eh (1150 decimal) → READY TO SWITCH ON
•
47Fh (1151 decimal) → OPERATING (Speed mode)
or
C7Fh (3199 decimal) → OPERATING (Torque mode)

Starting up ACSM1 drives

1. Power up the drive.
2. Enable the communication between the adapter module and
the drive by setting parameter 50.01 FBA ENABLE to
ENABLE.
3. With parameter 50.02 COMM LOSS FUNC, select how the
drive reacts to a fieldbus communication break.
Setting for ACS355
drives
8 = COMM
8 = COMM
8 = COMM
7 = COMM
8 = COMM
Description
Communication module as the
source for the control location
selection
Communication module as the
source for reference 1
Communication module as the
source for reference 2
Communication module as the
source for the Run enable signal
Communication module as the
source for the fault reset signal