ABB FCAN-01 User Manual page 104

104 Communication profiles
Status word of ABB Drives profile
Bit Name
10 ABOVE_
LIMIT
11 EXT_CTRL_
LOC
12 EXT_RUN_E
NABLE
13...14 Reserved
15 FBA_ERROR
Value STATE/Description
1 Actual frequency or speed equals or
exceeds the supervision limit (set with
the drive parameter). Valid in both
directions of rotation.
0 Actual frequency or speed within
supervision limit
1 External Control Location EXT2
selected
Note concerning ACS880: This bit is
effective only if the fieldbus interface is
set as the target for this signal by drive
parameters. User bit 0 selection
(06.33).
0 External Control Location EXT1
selected
1 External Run Enable signal received
Note concerning ACS880: This bit is
effective only if the fieldbus interface is
set as the target for this signal by drive
parameters. User bit 1 selection
(06.34).
0 No External Run Enable signal
received
1 Communication error detected by the
fieldbus adapter module.
0 Fieldbus adapter communication OK