Installing The Module - ABB FSE-31 User Manual

20 Mechanical installation

Installing the module

WARNING! Obey the safety instructions. See chapter
Safety instructions. If you ignore the safety instructions,
injury or death can occur.
Install the FSE-31 module onto an option module slot of the drive
control unit. Do not install the FSE-31 module onto an FEA-03
F-series extension adapter.
1. Stop the drive and do the steps in section
precautions
2. Pull out the lock.
3. Put the module carefully into its position on the drive until the
retaining clips lock it into position.
4. Push in the lock.
5. Tighten the mounting screw. The maximum tightening torque is
0.8 N·m (7.1 lbf·in).
Note: The mounting screw tightens the connections and
grounds the module. It is necessary for fulfilling the EMC
requirements and for proper operation of the module.
WARNING! Tightening the screw too much can cause
damage to the threads.
See the applicable drive manual for further instructions on how to
install the module to the drive.
on page 8 before you start the work.
Electrical safety