2.6 Checking the Charging Assemblies
Step
1
Remove the two screws, and detach the feed-
ing assembly front cover (right).
2
Remove the screw, and detach the metal fix-
ing; then disconnect the connector.
While holding the front and the rear of the
transfer/separation charging assembly at the
same time, pull it to the front to detach in the
left upper direction.
Check the transfer/separation charging as-
sembly; if dirt or paper lint is found, clean
with alcohol.
Mount the transfer/separation charging as-
sembly.
Connect the connector, and fit the metal fix-
ing.
Do not bring the transfer/separation
charging assembly into contact with the
transfer guide to avoid cutting the gut
wire. Further, be sure that the solvent has
evaporated completely.
3
Mount the feeding assembly front cover
(right) with two screws, and insert the fixing/
feeding assembly into the machine.
4
Remove the screw from the door tape (door
stopper) of the front door. (This is to keep
the hopper open, which otherwise may close
when the hopper is opened.)
COPYRIGHT © 2000 CANON INC.
Download Free Service Manual at http://printer1.blogspot.com
Work
2000 2000 2000 2000
CANON iR5000/iR6000 REV.0 JULY 2000
CHAPTER 3 INSTALLATION
Checks/remarks
Screws
Feeding assembly front cover
Metal fixing
Screw
Connector
3-9 S