Close Pilot Fan Door; Slide Pilot To Rack Position; Verify Component Replacement On The Standby Pilot; Figure 185: Location Of The Pilot Release Tabs - Oracle FS1-2 Customer Service Manual

Note: Apply firm pressure to fully seat the fan module into the fan
compartment. The fan modules are notched to ensure that they are
installed in the correct orientation.
3 Press down on the fan module and apply firm pressure to fully seat the fan
module.

Close Pilot Fan Door

Close the Pilot fan door by pressing the two release tabs on both sides of
the fan door until it locks into place.

Slide Pilot to Rack Position

1 Simultaneously pull and hold the two release tabs, one on each side of the
Pilot, toward the front of the Pilot while you push the Pilot into the rack.

Figure 185: Location of the Pilot release tabs

Note: As you push the Pilot into the rack, verify that the cable management
arm (CMA) retracts without binding.
Note: To pull the Pilot release tab, place your finger in the center of the tab,
not on the end, and apply pressure as you pull the tab toward the front of
the Pilot.
2 Continue pushing the Pilot into the rack until the slide-rail locks on the
front of the Pilot engage the slide-rail assemblies.
Note: The Pilot locks into the rack position with an audible click.

Verify Component Replacement on the Standby Pilot

If you replaced a component on the standby Pilot, complete the following steps
to verify the status of the Pilot:
Pilot Replacement Procedures
220