Insert A Power Supply; Figure 75: Remove Power Supply - Oracle FS1-2 Customer Service Manual

Figure 75: Remove power supply

Legend
2 If both power supplies must be removed, label the power supplies with the
slot numbers from which they are removed.
Note: Removing both power supplies will result in the immediate
powering off of the Controller. Do not pull both power supplies from an
active and running Controller.
Note: The power supplies must be reinstalled into the same slots from
which they were removed.
3 Pull the power supply out of the chassis and place it on an antistatic mat.

Insert a Power Supply

1 Slide the replacement power supply into the power supply compartment at
the back of the Controller until it is fully seated.
1 Power supply
2 Power supply compartment
3 Controller
Controller Replacement Procedures
107