Prepare A Drive Enclosure For Component Replacement; Remove An I/O Module - Oracle FS1-2 Customer Service Manual

Prepare a Drive Enclosure for Component Replacement

1 From Oracle FS System Manager (GUI), navigate to System > Hardware.
2 Select Drive Enclosures.
The GUI displays the Drive Enclosures Overview page. The Drive
Enclosures Overview page displays the status of the Drive Enclosure
components.
3 Select the Drive Enclosure containing the component that you want to
replace.
4 Select Actions > View.
The View Drive Enclosure dialog displays the list of replaceable Drive
Enclosure components in the Replaceable Unit list.
5 From the Replaceable Unit list, select the component that you want to
replace and click Replace Component.
Guided Maintenance displays the Introduction page, and guides you
through the steps to replace the Drive Enclosure component.
6 Click Next.
Guided Maintenance displays the Identify Hardware dialog.
7 From the Identify Hardware dialog, specify how you want to identify the
chassis so that you can locate it in the data center.
You can select one of the following methods to identify the chassis:
Identify
Reverse Identify
8 Click Next.
Based on the method you selected to identify the chassis, the
corresponding LEDs flash to help you locate the chassis in the data center.
9 Click Next.
Guided Maintenance completes the process of preparing a Drive Enclosure
for component replacement. After Guided Maintenance prepares the Drive
Enclosure for replacing a component, it displays the Replace Hardware
dialog box. The Replace Hardware dialog box instructs you to replace the
component. You also receive a System Alert informing you that the
component is ready for removal. To review System Alerts, select System >
Alerts and Events > System Alerts.

Remove an I/O Module

1 When Guided Maintenance prompts you to remove the component, label
and disconnect the SAS interface cables that are attached to the I/O
module.
Flashes the LEDs on the chassis that contains the failed component.
Flashes the LEDs on all of the chassis in the system except for the chassis that
contains the failed component.
Drive Enclosure Replacement Procedures
164