Insert A Pilot Dimm; Close Pilot Top Cover - Oracle FS1-2 Customer Service Manual

Insert a Pilot DIMM

1 Unpack the component from its shipping carton.
Note: Place the component on an antistatic mat if it must be set aside for
any reason.
2 Press the DIMM fully into the DIMM slot and ensure that the tabs on both
sides of the DIMM are locked.
Important: Ensure that the notch in the DIMM lines up with the key in the
slot.
Note: Replace only one DIMM at a time to make sure that they are inserted
into the correct slots. Attempting to insert multiple DIMMs into the slots
might damage the DIMMs due to excessive flexure.
Note: Never leave a DIMM slot unpopulated. Insert filler panels into
empty DIMM slots to ensure proper air flow inside the Pilot.

Close Pilot Top Cover

1 Place the top cover of the Pilot onto the chassis.
Tip: Place the top cover down so that it hangs over the back of the Pilot by
about 13 mm (0.5 inches) and the side latches align with the slots in the
sides of the Pilot chassis.
Note: There are three latching tabs on the sides of the Pilot top cover, two
on the right side and one on the left side when viewing the Pilot from the
front. There is also a latch on the underside of the top cover in the front left
corner near the release button.
2 Check both sides of the Pilot chassis to ensure that the four corners of the
top cover are fully down and flush with the chassis.
Note: If the cover corners are not flush with the Pilot chassis, slide the
cover towards the back of the chassis until you can position the cover
correctly.
Note: If the top cover is not correctly positioned before attempting to slide
the cover forward, the internal latch that is on the underside of the cover
might be damaged.
3 Gently slide the top cover along the grooves of the Pilot by pressing down
on either side of the top cover until it locks into place and you hear an
audible click.
Pilot Replacement Procedures
228