Lower The Drive Compartment; Figure 117: Reconnect Cables To The Backplane - Oracle FS1-2 Customer Service Manual

Note: Never leave a DIMM slot unpopulated. Insert fillers into empty slots
to ensure proper air flow inside the Controller.

Lower the Drive Compartment

1 Rotate the drive compartment and backplane back into position inside the
Controller and ensure that the alignment pins engage.
Note: To confirm that the backplane is locked into position, listen for an
audible click or feel the backplane engage with the Controller.
2 Secure the backplane inside the Controller by inserting the four Phillips
Number 2 thumb screws on the four sides of the backplane and tightening
them using a Phillips Number 2 screwdriver.
3 Reconnect all the cables that had been previously disconnected from the
backplane.
Cables that must be reconnected include:

Figure 117: Reconnect cables to the backplane

Legend
SATA or drive cable
•
NV-DIMM cable
•
Motherboard to HDD backplane cable
•
1 SATA or drive cable
2 NV-DIMM cable
3 Drive compartment
4 Backplane boards
5 Motherboard to HDD backplane cable
Controller Replacement Procedures
149