Mounting The Unit; Free-Stand Installation; Securing With Mounting Magnets - Omron EQUO Series User Manual

3.7

Mounting the Unit

This section describes the procedure to install the product.
Important
 This product is a sensitive device. Take caution not to let it drop when installing.
 Use screws to fix the product through the provided mounting screw holes for installation on the
wall or other equipment where vibration or shock may directly affect the unit.

3.7.1 Free-stand Installation

Important
 When placing the product on a desk or other elevated object, place it at a sufficient distance
from the edges or corners of the object to prevent the unit from dropping to be damaged.
 Be careful with handling of the power cable, dedicated CT, power sensor station cable, and
LAN cable to prevent them from being hooked.

3.7.2 Securing with Mounting Magnets

Two mounting magnets are provided on the rear side of ZN-CTX21. Use them to securely
mount the unit on the wall or other vertical surface.
Important
 Mount the unit on a location where mechanical shock is not applied when mounting it with
magnets.
 The cable layout also requires caution not to allow the sensor head and cable apply pressure
to the magnet-mounted unit.
Note
 ZN-KMX21 can be fixed using magnets by attaching attachment magnets ZN9-EM01-S
(separately sold) to the screw holes (fastening torque 0.4 to 0.6 N/cm).
Mounting Magnets
3-25
3. Check and Preparation