Show Bgp Bmp - Dell PowerConnect J-EX4200-24T Software Manual

show bgp bmp

Syntax
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
show bgp bmp show bgp bmp
show bgp bmp
Command introduced before Junos OS Release 10.2 for J-EX Series switches.
Display information about the BGP Monitoring Protocol (BMP).
This command has no options.
view
show bgp bmp on page 1805
Table 213 on page 1805 lists the output fields for the
fields are listed in the approximate order in which they appear.
Table 213: show bgp bmp Output Fields
Field Name
BMP station address/port:
BMP session state
Memory consumed by BMP
Statistics timeout
Memory limit
Memory-connect retry
timeout
user@host> show bgp bmp
BMP station address/port: 172.24.24.157+5454
BMP session state: DOWN
Memory consumed by BMP: 0
Statistics timeout: 15
Memory limit: 10485760
Memory connect retry timeout: 600
Chapter 74: Operational Commands for Layer 3 Protocols
show bgp bmp
Field Description
IP address and port number of monitoring station to which BGP
Monitoring Protocol (BMP) statistics are sent.
Status of the BMP session:
UP
Memory used by the active BMP session.
Amount of time, in seconds, between transmissions of BMP data
to the monitoring station.
Threshold, in bytes, at which the routing device stops collecting
BMP data if it is exceeded.
Amount of time, in seconds, after which the routing device attempts
to resume a BMP session that was ended after the configured
memory threshold was exceeded.
command. Output
or .
DOWN
1805