Dell PowerConnect J-EX4200-24T Software Manual page 1865

Table 208: show (ospf | ospf3) route Output Fields (continued)
Field Name Field Description
NextHop Interface (OSPFv2 only) Interface through which the route's next hop is reachable.
Nexthop addr/label (OSPFv2 only) If the
NH Type
Area ID of the route.
Area
Origin Router from which the route was learned.
Type 7 Route was learned through a not-so-stubby area (NSSA) link-state
advertisement (LSA).
Route was learned through NSSA LSA and the propagate bit was set.
P-bit
Forwarding address is nonzero.
Fwd NZ
through an NSSA LSA.
Optional capabilities propagated in the router LSA. This field is in the output for
optional-capability
intraarea router routes only (when
or
Router
field are defined as follows:
0x4 (V)
0x2 (E)
0x1 (B)
The priority assigned to the prefix:
priority
high
medium
low
NOTE: The
show ospf route show ospf route
show ospf route detail
NH Type is IP , then it is the address of the next hop. If the
is , then it is the name of the label-switched path.
LSP
Fwd NZ
Route Type
), not for interarea router routes or network routes. Three bits in this
—Routing device is at the end of a virtual active link.
—Routing device is an autonomous system boundary router.
—Routing device is an area border router.
field applies only to routes of type
priority
user@host> show ospf route
Prefix Path
addr/label
10.255.71.12 Intra
10.255.71.13/32 Intra
192.168.222.84/30 Intra
user@host> show ospf route detail
Topology default Route Table:
Prefix Path
Type
label
10.255.14.174 Inter
area 0.0.0.2, origin 10.255.14.185
Chapter 74: Operational Commands for Layer 3 Protocols
is only displayed if the route is learned
is Area BR , AS BR , Area/AS BR
.
Network
Route NH Metric
Type Type Type
Router IP 1
Network IP 0
Network LSP 1
Route NH Metric
Type Type
AS BR IP 210
Output Level
All levels
All levels
detail
detail
detail
detail
detail
detail
,
detail
NextHop Nexthop
Interface
fe-0/0/2.0 192.16.22.86
lo0.0
fe-0/0/2.0 lsp-ab
NextHop Nexthop
Interface addr/
t1-3/0/1.0
1793