Configuring Multicast Vlan Registration (Cli Procedure) - Dell PowerConnect J-EX4200-24T Software Manual

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS

Configuring Multicast VLAN Registration (CLI Procedure)

Related
Documentation
2068
Multicast VLAN registration (MVR) allows hosts that are not part of a multicast source
VLAN (MVLAN) to still receive multicast streams from the MVLAN, allowing an MVLAN
to be shared across a Layer 2 network. Hosts remain in their own VLANs for bandwidth
and security reasons but are able to receive multicast streams from the MVLAN.
You can configure one or more VLANs on a switch to be MVLANs or MVR receiver VLANs.
By default, MVR is not configured on J-EX Series switches.
NOTE: MVR is supported on VLANs running IGMP version 2 (IGMPv2) only.
NOTE: When configuring MVR, the following restrictions apply:
You cannot enable multicast protocols on VLAN interfaces that are
members of MVLANs.
If you configure an MVLAN in proxy mode, IGMP snooping proxy mode will
be automatically enabled on all MVR receiver VLANs of this MVLAN. If a
VLAN is an MVR receiver VLAN for multiple MVLANs, all of the MVLANs
must have proxy mode enabled or all must have proxy mode disabled. You
can enable proxy mode only on VLANs that are configured as MVR source
VLANs and that are not configured for Q-in-Q tunneling.
After you configure a VLAN as an MVLAN, that VLAN is no longer available
for other uses.
To configure MVR:
Configure the VLAN named
1.
[edit protocols]
user@switch# set igmp-snooping vlan mv0 data-forwarding source groups 225.10.0.0/16
Configure the MVLAN
mv0
2.
[edit protocols]
user@switch# set igmp-snooping vlan mv0 proxy source–address 10.0.0.1
Configure the VLAN named
3.
[edit protocols]
user@switch# set igmp-snooping vlan v2 data-forwarding receiver source-vlans mv0
Install forwarding entries in the MVR receiver VLAN:
4.
[edit protocols]
user@switch# set igmp-snooping vlan mv0 data-forwarding receiver install
Example: Configuring Multicast VLAN Registration on J-EX Series Switches on page 2058
Understanding Multicast VLAN Registration on J-EX Series Switches on page 2052
to be an MVLAN:
mv0
to be a proxy VLAN:
to be an MVR receiver VLAN:
v2