Dell PowerConnect J-EX4200-24T Software Manual page 1506

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 190: BGP Global Settings
Field Function
General tab
Router ASN Specifies the routing device's AS number.
Router Identifier Specify the routing device's IP address.
BGP Status Enables or disables BGP.
Description Describes of the global, group, or neighbor
configuration.
Confederation Specifies the routing device's confederation AS
Number number.
Confederation Specifies the AS numbers for the confederation
Members members.
Advance Options You can configure the following:
Keep routes
from a BGP peer must be retained in the routing
table even if they contain an AS number that was
exported from the local AS.
TCP MSS
(MSS) for the TCP connection for BGP neighbors.
MTU Discovery
Remove Private ASN
system strip private AS numbers from the AS path
when advertising AS paths to remote systems.
Graceful Restart
the restart is expected to be complete. Specify the
maximum time that stale routes are kept during
restart.
Multihop
(TTL) value for the TTL in the IP header of BGP
packets.
Authentication Type
algorithm: None, MD5, SHA1, AES.
Policies tab
1434
—Specifies whether routes learned
—Configures the maximum segment size
—Select to configure MTU discovery.
—Select to have the local
—Specifies the time period when
—Configures the maximum time-to-live
—Select the authentication
Your Action
Type or select and edit the value.
Type or select and edit the IP address.
To enable BGP, select
Enabled
To disable BGP, select
Disabled
Type or select and edit the description.
Type or select and edit the value.
To add a member AS number, click
the number in the Member ASN
To modify a confederation member's AS number,
select the member click and, enter the number
Edit
and click OK .
To delete a confederation member, select the
member and click .
Remove
Select All or None to configure Keep Routes.
Enter a value in the TCP MSS
Click to enable MTU Discovery
Click to enable Remove Private ASN
Enter the time period for a graceful restart and the
maximum time that stale routes must be kept.
To configure Multihop, select
allow unconnected third-party next hops. Enter a
TTL value.
Select the authentication algorithm. If you select
None, specify an authentication key (password).
.
.
and enter
Add
box. Click OK .
box.
.
.
to
Nexthop Change