Dell PowerConnect J-EX4200-24T Software Manual page 1409

Table 177: Spanning-Tree Protocol Configuration Parameters
Field Function
General
Protocol Name Specifies the spanning-tree protocol type: STP, MSTP, or
RSTP.
Disable Disables spanning-tree protocol on the interface.
BPDU Protect Specifies BPDU protection on all edge interfaces on the
switch.
Bridge Priority Specifies the bridge priority. The bridge priority determines
which bridge is elected as the root bridge. If two bridges
have the same path cost to the root bridge, the bridge
priority determines which bridge becomes the designated
bridge for a LAN segment.
Forward Delay Specifies the number of seconds an interface waits before
changing from spanning-tree learning and listening states
to the forwarding state.
Hello Time Specifies the time interval in seconds at which the root
bridge transmits configuration BPDUs.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes (J-Web Procedure)"
on page 334 for details about all commit options.
Click one:
2.
—Creates a spanning-tree protocol configuration.
Add
Select a protocol name.
a.
Enter information as described in Table 177 on page 1337.
b.
Click to apply changes to the configuration or click
OK
c.
saving changes.
—Modifies a selected spanning-tree protocol configuration.
Edit
Enter information as described in Table 177 on page 1337.
a.
Click to apply changes to the configuration or click
OK
b.
saving changes.
—Deletes a selected spanning-tree protocol configuration.
Delete
Chapter 66: Configuring Spanning-Tree Protocols
Commit Options > Commit
to cancel without
Cancel
to cancel without
Cancel
Your Action
None.
To enable this option, select the check box.
To enable this option, select the check box.
Select a value from the list.
Type a value.
Type a value.
. See "Using the
1337