Dell PowerConnect J-EX4200-24T Software Manual page 2311

Chapter 80: Operational Mode Commands for IGMP Snooping and Multicast
Table 287: show pim statistics Output Fields (continued)
Field Name
No route upstream
Nexthop Unusable
RP mismatch
RPF neighbor unknown
Rx Joins/Prunes filtered
Tx Joins/Prunes filtered
Embedded-RP invalid addr
Embedded-RP limit exceed
Embedded-RP added
Embedded-RP removed
Rx Register msgs filtering
drop
Field Description
Number of PIM control packets received when the router does not
have a unicast route to the the interface used to reach the upstream
router, toward the RP.
Number of PIM control packets with an unusable nexthop. A path
can be unusable if the route is hidden or the link is down.
Number of PIM control packets received for which the router has
an RP mismatch.
Number of PIM control packets received for which the router has
an unknown RPF neighbor for the source.
The number of join and prune messages filtered because of
configured route filters and source address filters.
The number of join and prune messages filtered because of
configured route filters and source address filters.
Number of packets received with an invalid embedded RP address
in PIM join messages and other types of messages sent between
routing domains.
Number of times the limit configure with the
statement is exceeded. The maximum-rps
number of embedded RPs created in a specific routing instance.
The range is from 1 through 500. The default is 100.
Number of packets in which the embedded RP for IPv6 is added.
The following receive events trigger extraction of an IPv6 embedded
RP address on the router:
Multicast Listener Discovery (MLD) report for an embedded RP
multicast group address
PIM join message with an embedded RP multicast group address
Static embedded RP multicast group address associated with
an interface
Packets sent to an embedded RP multicast group address
received on the DR
An embedded RP node discovered through these receive events is
added if it does not already exist on the routing platform.
Number of packets in which the embedded RP for IPv6 is removed.
The embedded RP is removed whenever all PIM join states using
this RP are removed or the configuration changes to remove the
embedded RP feature.
Number of register messages dropped because of a filter configured
for PIM register messages.
maximum-rps
statement limits the
2239