Hardware Reset Modes; Mode 1 - Firmware Reset; Mode 4 - Ip Reset; Mode 5 - Factory Default Reset - Extron electronics DMP 128 Plus User Manual

Hardware Reset Modes

NOTE: The reset modes listed below close all IP connections, Telnet connections, and
Mode 1 — Firmware Reset
Hold the
factory firmware. This recovers a unit that has incorrect code or updated firmware running.
All user files and settings are maintained.
Mode 4 — IP Reset
With power on, press and hold the
(~6 seconds). Release the button and, within 1 second, press it again to reset all IP address
settings to factory default.
The following changes take place:
•
•
•
•
•
•
If a second momentary press does not occur within 1 second, Mode 4 is exited.
Mode 5 — Factory Default Reset
With power on, press and hold the
(~9 seconds). Release the button and, within 1 second, press it again to return the
DMP 128 Plus to factory default conditions.
The following changes take place:
•
•
•
•
•
•
sockets.
button while applying power to restore the unit firmware back to the default
Reset
ARP program capability is enabled
Sets IP back to factory default (192.168.254.254)
Sets subnet mask back to factory default (255.255.255.0)
Sets gateway back to factory default (0.0.0.0)
Turns DHCP off
Sets digital I/O port mapping back to factory default
Sets all IP settings back to factory default (see Mode 4 above)
Mix-points are set to unit gain (0 dBFS) and the following connections are made
Input 1 is routed to output 1
•
Input 2 is routed to output 2
•
Input 3 is routed to output 3
•
Input 4 is routed to output 4
•
Input 5 is routed to output 5
•
Input 6 is routed to output 6
•
Input 7 is routed to output 7
•
Input 8 is routed to output 8
•
All audio inputs are set to unity gain
All outputs are unmuted and set to unity gain
Any inserted or active DSP is removed
All preset and group master memory is cleared
button until the reset LED blinks twice
Reset
button until the reset LED blinks 3 times
Reset
DMP 128 Plus • Installation 9