System Reset - Extron electronics SSP 200 User Manual

INPUT
2 3 4

System Reset

VOLUME
5
SURROUND SOUND PROCESSOR
Figure 13. Analog Gain Control
NOTES:
• If the gain level is too high, clipping may occur. When clipping occurs, the Input 5
button lights red.
• When using Mono or Mono to All listening mode, the left and right signals are
summed (in the digital domain), which can cause a boost in level up to 6 dB. This
type of clipping does not cause the clip indicator LED to light but is audible. If
using a mono mode, it is recommended that the input gain be reduced by 9 dB to
prevent clipping from occurring.
While the Input 5 button is held down, the LED bar lights from the bottom up to indicate the
current gain level (see table below).
Gain steps for each LED
19 dB to 24 dB
13 dB to 18 dB
7 dB to 12 dB
1 dB to 6 dB
‑5 dB to 0 dB
‑11 dB to ‑6 dB
‑17 dB to ‑12 dB
‑18 dB
The rear panel has a recessed Reset button that initiates various levels of soft resets
restoring various tiers of SSP 200 settings to their defaults. For different reset levels, press
and hold the button while the SSP 200 is running. Use a pointed stylus or small screwdriver
(such as an Extron Tweeker) to press the button.
The following Reset Modes Summary
how to activate them, and the result of that activation.
NOTES:
• The reset modes listed on the next page close all open IP and Telnet connections,
as well as close all sockets.
• The factory configured passwords for all accounts on this device have been set to
the device serial number. Passwords are case sensitive. If the SSP 200 is reset, the
passwords revert to the default, which is extron. A new password would need to
be configured to secure the device.
LEDs lit
All 8 LEDs on
Bottom 7 LEDs on
Bottom 6 LEDs on
Bottom 5 LEDs on
Bottom 4 LEDs on
Bottom 3 LEDs on
Bottom 2 LEDs on
Bottom LED on
table provides a list of the available reset modes,
SSP 200 • Panel Features 14