Extron electronics DMP 128 Plus User Manual page 15

LAN Ports — One (non-v models) or two (V models) RJ-45 ports provide a Gigabit
H
network connection for control and VoIP traffic. The host PC or control system and the
DMP 128 Plus must be connected to the same network. Two LEDs indicate status.
NOTE: Only DMP 128 Plus V models have two
have a single LAN port.
defaults:
LAN 1
IP Address
192.168.254.254
defaults:
LAN 2
IP Address
192.168.1.254
There are three ways the dual LAN ports can be configured on DMP 128 Plus V models:
1. Control and VoIP traffic on one LAN port — Both control and VoIP traffic can be
transported via a single LAN port.
NOTE: By default, control and VoIP traffic are both transported on
2. Control and VoIP traffic on one LAN port using a VLAN — Both control and
VoIP traffic can be transported via a single physical LAN port while utilizing a VLAN
for VoIP traffic.
3. Control and VoIP traffic on separate LAN ports — Control and VoIP traffic can
be transported on separate LAN ports with unique IP configurations.
AT Ports (AT models only) — Four RJ-45 ports form a Gigabit switch for use with
I
a Dante network. The AT ports use Dante protocol for digital audio transport (AT) and
allow the DMP 128 Plus AT to connect to a Dante audio network to form a larger matrix
(see Dante Controller
2-port switches for redundant Dante configuration. In redundant configuration, audio
traffic is duplicated. Ports 3 and 4 are the primary switch
secondary switch
(SEC)
USB Audio Port — One mini USB type B port connects to a computer and allows the
J
DMP 128 Plus to function as a 4x4 audio interface with a Windows or Mac computer.
Available sample rates are 48 kHz/16-bit.
Reset Button and LED —The reset button returns the DMP 128 Plus to different tiers
K
of default states. When using the reset button, the LED blinks to signify the different
reset modes (see Hardware Reset Modes
modes, the LED operates as a power indicator, matching the front panel power LED.
Subnet Mask Default Gateway
255.255.255.0 0.0.0.0
Subnet Mask Default Gateway
255.255.255.0 0.0.0.0
on page 107). The 4-port switch can be configured as two
(see Redundant Configuration
on page 9). When not displaying reset
ports. Non-V models only
LAN/VoIP
DHCP
OFF
DHCP
OFF
LAN 1
, ports 1 and 2 are the
(PRI)
on page 117).
DMP 128 Plus • Installation
.
7