Extron electronics DMP 128 Plus User Manual page 122

To rename a DMP 128 Plus AT receiver:
1. From the menu on the
Device
on the keyboard. The
<Ctrl+D>
2. From the
(Select a Dante Device..)
desired DMP 128 Plus AT (see figure 182,
3. On the screen, select the
Device View
4. Click on the name of the receiver to be renamed. The name becomes a text box with a
cursor ( ).
3
5. Enter the new name (up to 31 characters) using any combination of letters, numbers,
and special characters except for
6.
Press on the keyboard to confirm the name, or click another channel text box.
<Enter>
7. Repeat steps 4 through 6 to rename additional receiver channels.
8. When finished renaming receivers, close the
Figure 182. Device View Screen — Renaming a Receiver
Renaming a Transmitter
The default names shown in the
interface of the connected device (see
of DMP 128 Plus AT transmitters is labelled
DMP 128 Plus AT can transmit signal routed to the analog outputs to the Dante network.
The second set of DMP 128 Plus AT transmitters is labelled
because the DMP 128 Plus AT can transmit signal routed to the EXP outputs
Exp_Out-16
to the Dante network. Follow the instructions on the next page to rename a transmitter.
screen, select
Network View
dialog box opens.
Device View
drop-down menu, select the name of the
below).
1
tab (
Receive 2
, , and (period).
@ = .
Device View
column are extracted from the Dante
Dante Transmitters
figure 181, on the previous page). The first set
2
through
Output-01
DMP 128 Plus • Dante Controller
, or press
Device View
).
dialog box.
because the
Output-08
through
EXP-Out-01
114