Dante Controller Operation; Dante Transmitters And Receivers - Extron electronics DMP 128 Plus User Manual

To configure the DMP 128 Plus AT in redundant mode using DSP Configurator:
1.
2.
3.
4.
5.
6.

Dante Controller Operation

Dante Transmitters and Receivers

A Dante network is comprised of transmitters that output digital audio onto the Dante
network and receivers that receive digital audio input from the Dante network.
•
•
DMP 128 Plus AT Transmitters and Receivers
In the DMP 128 Plus AT, the line output and EXP output channels are Dante transmitters
because their audio output is transmitted onto the Dante network. Routing an analog
output to the Dante network allows the signal to be output on both analog and Dante
simultaneously, the same is true for the EXP outputs.
The DMP 128 Plus AT EXP input channels are Dante receivers because they receive digital
audio signal from the Dante network that can then be routed and mixed into the
DMP 128 Plus AT mix matrix.
Use DSP Configurator to connect to the DMP 128 Plus AT in Live mode (see
Emulate Panel
on page 18).
Select
Tools > Device Settings
In the dialog box, use the right navigation arrow (
Device Settings
and select the
Dante Device
Select
Enable Redundant Mode
Select or
DHCP Static IP
Click ( ).
4
Apply
Figure 189. Redundant Mode Configuration in DSP Configurator
Transmitters output digital audio from the device onto the audio network.
Receivers take in digital audio from the audio network into the device.
.
tab (see figure 189, below).
1
( ).
2
and enter a valid redundancy network configuration (
DMP 128 Plus • Dante Controller
Live and
) to navigate to
).
3
118