Connection And Configuration; Connecting The Hardware; Ethernet Connection - Extron electronics IP Link IPL T CR48 User Manual

Connection and
Configuration
This section discusses how to connect and configure the IPL T CR48. Topics that are
covered include:
•
•

Connecting the Hardware

To connect the IPL T CR48, connect the input and output devices to the unit (see figure 9).
Extron
IPL T CR48
Ethernet Control
Interface
Figure 9.

Ethernet Connection

This type of connection is used on an ongoing basis to connect the IPL T CR48 to a LAN
and to control switching and display devices through the unit.
1.
2.
3.
Connecting the Hardware
Configuring the Hardware
Blinds
2
1
6
T 5
P U
IN
4
3
2
1
L A N
R
W E
P O
V
12
0. 5A
TCP/IP
Network
GlobalViewer
®
A/V Resource
Management and
Remote Control
Application
Example Application
Plug one end of a CAT 5, straight-through Ethernet cable into the rear panel Ethernet
connector on the IPL T CR48 (see
Plug the other end of the Ethernet cable into a network switch, hub, or router
connected to an Ethernet LAN or to the Internet.
Launch your web browser on your PC and type the web address that you set up on the
IPL T CR48 (see IPL T CR48 Interface Configuration
field of the browser. The IPL T CR48 default web page displays.
Screen
Control
Projector
Lift
Control
Projector
4
3
8
7
Lighting System
figure 7 on page 7 for RJ-45 connector wiring).
IPL T CR48 • Connection and Configuration
on page 13) in the
Address
11