Dante Routing Operation; Routing Devices - Extron electronics DMP 128 Plus User Manual

Dante Routing Operation

Dante Controller is used for all network signal routing of transmitters and receivers for
Dante-enabled devices. The DMP 128 Plus AT transmitters and receivers are available
in Dante Controller for routing to other Dante devices (see
Receivers

Routing Devices

After the DMP 128 Plus AT is configured, the channels can be routed to the other Dante
devices on the audio network. Channels transmitted to the network or received from the
network are routed using the Dante Controller
(see figure 190
the screen, and the receivers, listed vertically down the left side, form a matrix whose
intersections are the connection points between the receivers and transmitters.
• To make a receiver-to-transmitter connection, click once on an intersection.
• To remove a connection, click on the icon at the intersection.
One of the following icons appears at each connection intersection, indicating the status of
both the transmitter and receiver channels and the connections (subscriptions):
Icon Description
Indicates an active subscription.
Indicates subscription is in progress.
Indicates a pending subscription.
Indicates a broken subscription.
Indicates the transmitting device has been removed from the network or is
switched off.
See the Dante Controller User Guide, available at www.audinate.com, for additional
information.
Creating Subscriptions Between Transmitters and Receivers
1. Ensure the control computer and DMP 128 Plus AT are connected to the same
network.
2.
From the start menu select:
All Programs > Audinate > Dante Controller > Dante Controller
The
Dante Controller - Network View
page).
Dante Controller auto-discovers Dante devices on the network and advertises itself to
allow other Dante-enabled devices to communicate with it. Transmitters connect to
receivers using the subscription matrix.
on the previous page).
on the next page). The transmitters, listed horizontally along the top of
Dante Transmitters and
tab on the
Routing Network View
screen opens (see figure 190
DMP 128 Plus • Dante Controller
page
on the next
119