Extron electronics DMP 128 Plus User Manual page 28

If only pushing selected presets, mark them from the dialog box shown in figure 31
below.
Figure 31. Preset Selection Dialog Box
4. Once a push or pull is completed, the current state of the connected DMP 128 Plus
is displayed in the DSP Configurator status panel and the device is ready for further
configuration.
Exit Live Mode and Enter Emulate Mode
1. Click the button in the DSP Configurator menu bar (see figure 32,
Emulate
Alternatively, select
Tools > Disconnect from Device
Figure 32. Emulate Button
2. Click to confirm.
OK
Figure 33. Confirm Disconnect
or press
<F6>
DMP 128 Plus • DSP Configurator Software
).
1
on the keyboard.
20