Renaming The Dmp 128 Plus At In Dante Controller - Extron electronics DMP 128 Plus User Manual

Renaming the DMP 128 Plus AT in Dante Controller

NOTE: Dante device naming can also be done via DSP Configurator (see
on page 92).
1. Ensure that the control computer and a single DMP 128 Plus AT are connected to the
same network.
2. From the control computer
All Programs > Audinate > Dante Controller > Dante Controller
3. The
Dante Controller - Network View
network are discovered and listed.
4. From the
figure 176 below).
Figure 176.
5. The
Dante Controller - Device View
configured from the
below).
Figure 177.
NOTES:
•
•
The
Device View
Figure 178.
Start
menu, select
Device Device View
Opening Device View
(Select a Dante Device...)
Device View and Select a Dante Device Drop-Down
If there are multiple DMP 128 Plus devices connected to the network that
have not been renamed, obtain the Dante interface media access code (MAC)
address of the desired device from the white label on the rear panel of the
device in order to identify it in Dante Controller.
There are two MAC addresses listed on the rear panel of a DMP 128 Plus AT,
one for the LAN port and one for the Dante interface. The Dante interface MAC
address is listed beneath the LAN port MAC address.
dialog populates with the selected DMP 128 Plus AT information.
Populated Device View Dialog Box
menu select:
screen opens. All Dante devices on the
or press
<Ctrl+D>
dialog opens. Select the device being
drop-down list (see figure 177,
DMP 128 Plus • Dante Controller
Dante Device
on the keyboard (see
1
111