Live And Emulate Modes - Extron electronics SSP 7.1 User Manual

Live and Emulate Modes

The SSP 7.1 Setup and Control Software offers a choice of
mode, any changes made using the software directly affect the configuration of the sound
processor.
In Emulate mode, the computer is not connected to the sound processor and any changes you
make must be saved as an *.esp file. The file can be used later to update the configuration of the
sound processor when the computer is directly connected to the SSP 7.1 in Live mode.
You may choose between Live and Emulate modes either when the program first starts up in
the
when the main program window is running, using the
Emulate
You can also toggle between the two modes, by using the <
Connect... (F5)
When you switch from Emulate to Live mode, you are prompted to synchronize the settings in
the SSP 7.1 Control and Setup Software with the current configuration in the SSP 7.1 device.
Select
Emulate mode, or select
device.
Synchronize with Device
Figure 17.
When the SSP 7.1 Control and Setup software is opened directly to Live mode, the current
configuration in the device is read from the SSP 7.1 unit, automatically overwriting the settings
in the software. When the program is closed, you are prompted to save any changes that have
been made during that session.
Figure 18.
Connect to device? Dialog Box
buttons in the top right corner (see the figure at right).
or
Disconnect (F6)
to overwrite the configuration in the device with the software settings made in
Push
to overwrite the software settings with the configuration in the
Pull
You have elected to change from Emulate mode to
Live mode. The data in this con guration must be
synchronized with the data in the device. Please
select an option below to continue:
Pull data from the device and update this
con guration.
Push the data from this con guration to
device, overwriting any data currently in it.
OK
Synchronize with Device Dialog Box
Save changed configuration Box
or
Live
(see the next page) or,
and
Live
> and <
F5
under the Device menu (see page 45).
Cancel
SSP 7.1 • Setup and Control Software
mode. In Live
Emulate
> keys or clicking on
F6
21