Aux Outputs; Naming An Aux Output - Extron electronics DMP 128 Plus User Manual

5
6
7
8
9

Aux Outputs

Four Aux outputs (non-V models) or eight Aux outputs (V models only) are available in the
Aux Outputs
USB audio via the rear panel USB audio port or to a VoIP network via a rear panel LAN port
(V models only).
Figure 107.

Naming an Aux Output

1.
2.
3.
dBFS Text Readout — Displays a numerical readout of the output signal level.
Polarity Button — Click this button to invert the signal polarity of the selected output.
When the button displays the black
When the button displays the black
inverted.
Mute Button — Mutes the signal at the output stage.
OK Button — Confirms changes made to the contained parameters and closes the
dialog box.
Attenuation
Cancel Button — Reverts any changes made to the contained parameters back to
their states when the current instance of the
closes the dialog box.
panel. These outputs can be configured to route signal to a host computer as
Aux Outputs Panel
Click the Aux output name field.
Figure 108. Aux Output Name Field
Delete the text and type the desired Aux output name.
Figure 109. New Aux Output Name
Press the key or navigate away from the field to confirm and apply the new
<Enter>
output name. Press the
<Down Arrow>
Figure 110. Renamed Aux Output
NOTE: Follow the same procedure to edit an Aux output name.
symbol on a gray field ( ), the polarity is normal.
+
symbol on a yellow field ( ), the polarity is
-
dialog box was opened and
Attenuation
to navigate to and highlight the next name field.
DMP 128 Plus • DSP Configurator Software 62