Expansion And At Inputs Overview; Expansion And At Inputs Processing; Mix-Points - Extron electronics DMP 128 Plus User Manual

12x8 prodsp digital matrix processor
Hide thumbs Also See for DMP 128 Plus:
Table of Contents

Advertisement

Expansion and AT Inputs Overview

With the Extron Expansion Port (EXP), two EXP enabled devices can be connected for
bidirectional communication of 16 audio channels. When two units are connected, one
unit must be set as the Primary Unit and the other must be set as the Secondary Unit (see
Expansion Bus
AT inputs allow a DMP 128 Plus AT model to receive signal from the audio network.
Network audio routing is done with Dante Controller (see
Figure 91.

Expansion and AT Inputs Processing

The expansion and AT inputs contain two processor blocks in their signal chain:
1.
2.
Expansion and AT Input Automix Block
One automix block is available for each expansion and AT input. This block functions the
same as the mic/line input automix block (see
information on configuring the EXP input automix block).
Expansion and AT Input Pre-Mixer Gain Block
The expansion and AT input pre-mixer gain block functions the same as the mic/line input
pre-mixer gain block (see
configuring the virtual return pre-mixer gain block).

Mix-Points

DSP Configurator contains twelve mix matrices that connect all inputs and outputs
(see figure 92
Each input is connected to a mix-point for the signal to be routed to an output. In general,
mix levels are set relative to each other, achieving a blend of input signals at an optimal
output level, close to, but not exceeding 0 dBFS at the output.
NOTE: In order for mix-points to appear in the workspace, the input group sending
on page 93). This synchronizes the sampling clocks of the two units.
Expansion Bus Panel with AT and Expansion Inputs
Automix Block
Pre-mixer Gain Block
Input Pre-Mixer Gain Block
on the next page). The mix matrices set post-processing mix levels.
signal to the mix-point must be expanded and the input channel must be visible.
Dante Controller
Input Automix Block
on page 40 for
on page 42 for information on
DMP 128 Plus • DSP Configurator Software
on page 107).
54

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dmp 128 plus cDmp 128 plus c v atDmp 128 plus c vDmp 128 plus c at

Table of Contents