Error Responses; Simple Control Port Commands - Extron electronics DMP 128 Plus User Manual

Error Responses

When the DMP 128 Plus is unable to execute the command, it returns an error response to
the host. The error response codes and their descriptions are as follows:
E10 —
E12 —
E13 —
E14 —
E17 —
E18 —
E22 —

Simple Control Port Commands

Upper and lower case text can be used interchangeably except where noted. Port 23 is the
default port for Telnet. Port 80 is the default port for Web browsers. Both can be mapped to
different ports.
Unrecognized command
Invalid port number
Invalid parameter
Not valid for this configuration
Invalid command for signal type
System/command timed out
Busy
DMP 128 Plus • Remote Control and Configuration
E24 — Privilege violation
E25 — Device not present
E26 — Maximum number of connections
exceeded
E27 — Invalid event number
E28 — Bad filename or file not found
E31— Attempt to break port pass-
through when not set
128