Options; Expansion Bus; Connecting The Exp Ports - Extron electronics DMP 128 Plus User Manual

Options

The
DSP Configurator color schemes, default processor and gain block behavior, as well as a
number of other settings. For a comprehensive overview of the
DSP Configurator Help file.
Figure 159.

Expansion Bus

With the Extron Expansion (EXP) port, two EXP-enabled devices can be connected for
bidirectional streaming of up to 16 channels of audio. EXP inputs and outputs contain DSP
(see

Connecting the EXP Ports

When connecting a DMP 128 Plus to another EXP-enabled device for EXP communication,
one of the devices must be set as the primary unit. The primary unit serves as the master
clock for all EXP audio communication. The other unit must be set as a secondary unit in
order for a connection to be established.
There are two different procedures for setting up DMP 128 Plus for EXP communication.
The first procedure describes how to set up a DMP 128 Plus non-AT model with another
EXP-enabled non-AT device for EXP communication (see
non-AT with Another EXP-Enabled non-AT Device
The second procedure describes how to set up a DMP 128 Plus AT model with another
EXP-enabled non-AT device for EXP communication (see
Device and an EXP-enabled non-AT Device
NOTE: Two DMP 128 Plus AT models cannot be connected via the EXP port because
dialog box allows the user to edit and reset default options for
Options
Options Dialog Box
Expansion and AT Inputs
AT models can only be configured as a primary unit and cannot be set as a secondary
unit. Instead, use the rear panel AT switch to connect the two devices over a Dante
network (see Dante Controller
on page 53 and Expansion Outputs
Connecting a DMP 128 Plus
on the next page).
Connecting a DMP 128 Plus AT
on page 95).
on page 107).
DMP 128 Plus • Configuration Tools
dialog box, see the
Options
on page 64).
93