Dante Device - Extron electronics DMP 128 Plus User Manual

Dante Device

Using the navigation buttons (
to the right of the
configured within DSP configurator without opening Dante Controller.
ATTENTION: It is essential that a Dante device be named immediately after it is
connected to the Dante network and before audio connections with other devices are
established. Existing connections are removed when a device is renamed.
Dante Device Name
A Dante device can be renamed to identify the device on the audio network.
To assign the Dante device name:
1.
Select
2. Use the arrows to navigate to the
3. Click the
4. Enter a device name for the Dante interface.
5. Click
Apply
6.
Click
Yes
Dante Device Network Settings
To configure Dante network settings:
1. Select the
Dante interface will be assigned an IP address by the DHCP server and Dante network
configuration is complete. If
2. Enter a valid network configuration into the
respective fields.
3. Click
Apply
To reboot the Dante interface:
1.
Click
Reboot Dante
Dante interface will reboot, not the entire
DMP 128 Plus.
To refresh the device name and network
configuration displayed:
1. Click
Refresh
refresh information from the DMP 128 Plus
Dante interface.
Redundant Mode
In redundant mode, the 4-port AT switch acts as two separate 2-port switches that
duplicate audio traffic (see
To enable redundant mode:
1. Click the
2. By default, the
configuration in the text boxes that appear below. Otherwise, select the
button to have the DHCP server assign a redundant network configuration.
NOTE: A valid redundant static network configuration must be entered.
) is required to view the
tab. This tab allows the DMP 128 Plus Dante settings to be
Date/Time
Tools > Device Settings
text box (
Device name 2
( ). A confirmation dialog box opens.
3
, to confirm existing connections will be removed after the name is changed.
or radio buttons (
DHCP Static IP
Static IP
.
( ). Only the
5
( ) to have DSP Configurator
6
Redundant Configuration
Enable Redundant Mode
radio button is selected. Enter the redundant network
Static
Dante Device
.
tab (see figure 158,
Dante Device
).
). If using DHCP, the DMP 128 Plus
4
is selected, proceed to step 2.
Figure 158. Dante Device Tab in
Device Settings Dialog
Box
on page 117).
checkbox.
DMP 128 Plus • Configuration Tools
tab, as it is located
below).
1
radio
DHCP
92