Acp 100 Configuration Example - Extron electronics DMP 128 Plus User Manual

ACP 100 Configuration Example

1.
From the DMP 128 Plus main workspace in DSP Configurator, select
Tools > Configure ACP Panels
2. Select an empty tab from the top of the dialog box to build a new configuration (see
figure 166,
3. From the
dialog box populates with an ACP 100 graphic.
4. From the
bus ID set on the ACP 100 rear panel DIP switch assembly (see the ACP 100 Setup
Guide for information on setting the bus ID).
5. In the panel graphic on the left side of the
labeled
configuration.
6. From the
side of the
a. From the
microphone source channels. This group must be created from the
Groups
Groups
b. From the
microphone source channels.
Figure 166.
7. From the panel graphic on the left side of the dialog box, select the button labeled
(see figure 166,
8. From the
a. From the
program source channels.
b. From the
program source channels.
. The
below).
1
drop-down, select
ACP Panel Type
drop-down menu (
3
ID #
is highlighted (yellow). When a button is highlighted, it is selected for
MIC
drop-down, choose
Control Type
dialog box, more configuration options appear.
Configure ACPs
drop-down (
Volume Master
dialog box before it can be selected from the drop-down (see
on page 70).
drop-down (
Mute Master
Starting ACP 100 Configuration
above).
7
drop-down, choose
Control Type
drop-down (
Volume Master
drop-down (
Mute Master
dialog box opens.
Configure ACPs
( ). The
2
ACP 100
), select the ID number that corresponds with the
dialog box, the button
Configure ACPs
Selector-Vol/Mute
), select the gain group containing all
5
), select the mute group containing all
6
Selector-Vol/Mute
), select the gain group containing all
5
), select the gain group containing all
6
DMP 128 Plus • Audio Control Panels
Configure ACPs
( ). On the right
4
Configure
Configuring
PRGM
( ).
4
101