Output Processing; Output Trim Block - Extron electronics DMP 128 Plus User Manual

Output Processing

The output processing chain in DSP Configurator is represented by a string of blocks (see
figure 102 below). Each block contains a specific processor or type of processor. Each
output contains the following processor chain:
1.
2.
3.
4.
5.
Figure 102.

Output Trim Block

Double-click the output
Figure 103.
The
the selected output.
Figure 104.
1
2
3
4
5
Output Trim Block
Output Delay Block
Output Filter Block
Output Dynamics Block
Output Attenuation Block
Output Processing Chain
block to open the
Trim
Output Trim Block
dialog box provides pre-processing gain and attenuation control for
Post-mixer Trim
Output Name
1
Post-mixer Trim Fader
2
Post-mixer Trim Text Box
3
OK Button
4
Cancel Button
5
Post-mixer Trim Dialog Box
Output Name — This name changes to match the default or user defined output name.
Post-mixer Trim Fader — Click and drag the trim fader to provide up to 12 dB of gain
or 12 dB of attenuation in 0.1 dB steps. Click the trim fader and use the
to adjust the fader up or down in 0.1 dB steps.
<Down Arrow>
Post-mixer Trim Text Box — Allows the user to enter a gain or attenuation value in
0.1 dB steps.
OK Button — Confirms changes made to the contained parameters and closes the
dialog box.
Post-mixer Trim
Cancel Button — Reverts any changes made to the contained parameters back to
their states when the current instance of the
and closes the dialog box.
dialog box.
Post-mixer Trim
dialog box was opened
Post-mixer Trim
DMP 128 Plus • DSP Configurator Software
or
<Up Arrow>
60