Table of Contents
Advertisement
Reference
Material
This section describes:
•
•
•
•
Network Port Requirements and Licensed Third-party Software Used
by the Touchpanels
For information about network port requirements and licensed third-party software for all the
touchpanels described in this guide, please refer to the Pro Series Control Product Network
Ports and Licenses Guide, which is available at www.extron.com.
Reset Modes
The TLI Pro 101 has three reset modes that are initiated by pressing the Reset button:
•
•
•
•
The
Use Factory Firmware
This mode is used to boot up the unit with factory-installed firmware for a single power cycle if
a firmware update fails or incompatibility issues arise with user-loaded firmware.
Activation
To start the Use Factory Firmware reset mode and replace firmware:
1.
2.
3.
Network Port Requirements and Licensed Third-party Software Used by the
Touchpanels
Reset Modes
Secure Sockets Layer (SSL) Certificates
IEEE 802.1X Certificates
Use Factory Firmware
Reset All IP Settings
Reset to Factory Defaults
Enable or Disable the DHCP Client
Reset
button is found on the rear panel (see
Remove power from the touchpanel.
On the touchpanel, hold down the recessed
applying power to the unit. When power is restored, the Reset LED (
button for a further two seconds before releasing it. The touchpanel enters factory
Reset
firmware mode.
Upload new firmware to the unit as desired (see
NOTE:
Do not continue to operate the touchpanel using the factory firmware
version. If you want to use the factory default firmware, you must upload that
version again (see
Updating the
figure
2,
G
on page 5).
button (see
figure
Reset
Updating the Firmware
Firmware).
TLI Pro 101 • Reference Material
2,
G
) while
F
) lights. Hold the
on page 27).
30
Advertisement
Table of Contents
