Renaming A Receiver Or Transmitter - Extron electronics DMP 128 Plus User Manual

Renaming a Receiver or Transmitter

In addition to renaming devices, individual receiver and transmitter channels can be
renamed in Dante Controller. To better organize the various receivers and transmitters,
it is recommended each receiver and each transmitter be named using a description of
the device they belong to, the location of the device, or the purpose of the receiver or
transmitter.
To view the receiver or transmitter channels in Dante Controller, click the
receiver or transmitter device name to expand it. The
device is expanded (see figure 181,
Figure 181.
To simplify setup and operation of large matrix systems, rename the receiver and
TIP:
transmitter channels to better indicate the source at the transmitters or receivers.
Renaming a Receiver
The default names shown in the
interface of the connected device (see figure 181,
receivers are labelled
receive signal at the 48 EXP inputs. Follow the instructions on the next page to rename a
receiver.
below).
1
Expanded Device View — Input and Output Names
Dante Receivers
through
EXP_In-01
+
sign becomes a
column are extracted from the Dante
above). The DMP 128 Plus AT
1
because the DMP 128 Plus AT can
EXP_In-48
DMP 128 Plus • Dante Controller
+
sign next to the
sign when the
–
113