Output Delay Block; Output Filter Block; Output Dynamics Block; Output Attenuation Block - Extron electronics DMP 128 Plus User Manual

Output Delay Block

One delay block is available for each output channel. This block functions the same as
the mic/line input delay block (see
configuring the output delay block).

Output Filter Block

One filter block is available for each output channel. This filter block functions the same as
the mic/line input filter block, except that there are 10 slots for filters instead of 5 (see
Filter Block

Output Dynamics Block

One dynamics block is available for each output channel. This block functions the same
as the mic/line input dynamics block (see
information on configuring the output dynamics block).

Output Attenuation Block

Double-click the output
Figure 105.
The
Attenuation
Figure 106.
Output Name — This name changes to match the default or user defined output name.
1
Output Attenuation Fader — Click and drag the trim fader to provide up to 100 dB
2
of attenuation. Click the trim fader and use the
the fader up or down in 1 dB steps.
Output Attenuation Text Box — Allows the user to enter a gain or attenuation value in
3
0.1 dB steps.
dBFS Meter — Provides post-attenuation and pre-mute a readout of the output signal
4
level.
Input Delay Block
on page 26 for information on configuring output filters).
block to open the
Attenuation
Output Attenuation Block
dialog box provides attenuation control for the selected output.
Output Name
1
Output Attenuation Fader
2
Output Attenuation Text Box
3
dBFS Meter
4
dBFS Text Readout
5
Attenuation Dialog Box
on page 37 for information on
Input Dynamics Blocks on page 32 for
Attenuation
Polarity Button
6
Mute Button
7
OK Button
8
Cancel Button
9
or
<Up Arrow> <Down Arrow>
DMP 128 Plus • DSP Configurator Software
Input
dialog box.
to adjust
61