Configuring A Macro - Extron electronics DMP 128 Plus User Manual

Configuring a Macro

1.
Click
Tools > Configure Macros
2. Select an empty macro slot from the
3. From the
Local
choosing
NOTE: If the remote device has already been added, it is listed in the drop-down
list.
a. After selecting
box opens.
b. Complete the form in the dialog box, including username and password, if required.
c. Select
d.
Click
e. Select the newly created remote destination from the
4. From the
Recall Preset — Recall an existing preset.
•
Set Group Gain — Set the level of an existing gain group.
•
Set Group Gain Inc/Dec — Set the increment/decrement values of an existing
•
gain group.
Set Group Mute — Mute or unmute an existing mute group.
•
Gain — Set the gain of a specific gain block on a specific channel.
•
Mute — Mute or unmute a specific gain block on a specific channel.
•
Set Phantom Power – Enable or disable phantom power on a specific
•
Mic/Line input channel.
Meters On/Off — Enable or disable level meters at the input gain or output
•
attenuation stages of a specific channel.
Set Input Format — Specify whether mic/line inputs receive analog signal from the
•
inputs or digital signal via the Dante network (see
SIS Command — Type in a single SIS command to perform an action not listed
•
above (see
NOTE: Use the
5. Once the action is chosen, up to four additional selections must be made. For example,
if
Set Group Gain
group to be affected and
set to.
6. When all of the action selections are configured, a new line appears at the bottom of the
form so another action can be configured.
7. From the
response from each action before executing the next action in the macro or executes
the next command immediately without waiting for an SIS response. The default is
Execute immediately
follow SIS response syntax (see
a. If
keyboard or the arrows to the right of the field to enter the amount of delay in
seconds. The default is
drop-down, select a destination for the macro action. Choose
Destination
for the local DMP 128 Plus, or
, proceed to step 4.
Local
Add Destination...
to add the device to the drop-down in the
Apply
to close the
Close Edit Remote Destinations
drop-down, select an action to be configured.
Action
Remote Communication and Control
key in place of
W
is the selected action,
Selection 2
drop-down, select whether the DMP 128 Plus waits for an SIS
Next Command
. Responses can be viewed through Extron Dataviewer and
DSP SIS Commands
was selected, the
Wait for response
0.000
. The dialog box opens.
Configure Macros
drop-down.
Select Macro
Add Destination...
, the
Edit Remote Destinations
Destinations
dialog box.
Destination
in figure 45
9
on page 123).
E
and the (pipe) key in place of
|
prompts the selection of a gain
Selection 1
determines the gain level the selected group is
on page 141).
field becomes active. Use the
Delay
seconds of delay.
DMP 128 Plus • Configuration Tools
for a remote destination. If
dialog
column.
drop-down.
on page 25).
}
.
79