15.
From the panel graphic on the left side of the dialog box, select the button labeled
PROGRAM
16.
From the
a.
From the
program source channels.
b.
From the
program source channels.
Figure 172.
The ACP 106 panel is now fully configured. From this point, either:
Add additional ACP panel configurations.
•
•
Save the ACP panel configuration to the DSP Configurator configuration file (see Saving
and Pushing ACP Configurations below).
•
Push the configurations to the DMP 128 Plus (see Saving and Pushing ACP
Configurations below).
Saving and Pushing ACP Configurations
1.
Configure up to four ACP panels.
2.
Close the
box is closed.
3.
Save the configuration file. ACP configurations are saved with the configuration file.
4.
Connect Live to a DMP 128 Plus via a LAN (TCP/IP) connection.
NOTE: The host computer must be connected to the DMP 128 Plus LAN port in
order to push ACP configurations to the device.
5.
Select
6.
Click
Push Configuration to Device
Configure ACPs
(see figure 172,
below).
©
drop-down (
Control Type
drop-down (
Volume Master
drop-down (
Mute Master
Configuring Mic and Program Selector Buttons
dialog box. Button configurations remain after the dialog
Configure ACPs
Tools > Configure ACP Panels
dialog box are pushed to the DMP 128 Plus.
), choose
ª
Selector-Vol/Mute
), select the gain group containing all
«
), select the gain group containing all
¬
. The
dialog box opens.
Configure ACPs
. Configurations from all four tabs in the
DMP 128 Plus • Audio Control Panels
.
106