Host-To-Device Communications; Dmp 128 Plus-Initiated Messages - Extron electronics DMP 128 Plus User Manual

Host-to-Device Communications

The commands listed in the following tables perform the same functions, but are encoded
differently to accommodate the requirements of each Telnet or browser port.

DMP 128 Plus-initiated Messages

The DMP 128 Plus initiates messages under specific conditions. No response is required for
the host. The DMP 128 Plus-initiated messages are listed below.
Copyright Message
The DMP 128 Plus initiates the following copyright message when it is first powered on or
when a connection via IP is established:
(c) Copyright 2016—2017, Extron Electronics, DMP 128 Plus {model}, Vn.nn,
60-nnnn-nn
Day, DD MMM YYYY HH:MM:SS
•
•
•
The DMP 128 Plus sends the boot and copyright messages under the following
circumstances:
•
•
Password Prompt
The
return. The prompt is repeated if the incorrect password is entered.
If the correct password is entered, the unit responds with
]
administrator and user, the unit will default to administrator privileges.
]
is the firmware version number.
Vn.nn
is the full model name. DMP 128 Plus C, for example.
{model}
is the DMP 128 Plus part number.
60-nnnn-nn
If the DMP 128 Plus is off and RS-232 connection is already set up (the PC is cabled to
the DMP 128 Plus and a serial communication program such as DataViewer is open),
the connected unit sends these messages via RS-232 when first powered on.
The DMP 128 Plus sends the boot and copyright messages when a Telnet connection
to the DMP 128 Plus is opened via Telnet, but not via RS-232. If using a Telnet
connection, the copyright message, date, and time may be followed by a password
prompt.
]
prompt requires an administrator or user password followed by a carriage
Password
]
depending on the password entered. If passwords are the same for both
Login User
]
]
DMP 128 Plus • Remote Control and Configuration
]
Login Administrator
or
126